The Machine:

• Simple Ergonomic Design,

• Compact: Length 64 inches, Width 45 inches, Height 68 inches

• Machine Weight Approx 2500 LBS

• Power requirement: 220 Volt 3 Phase 15 Amps

• Connected Horse Power 5 AC Heavy Duty Leeson Motor

• Sliding Door Opening 21" x 21"

• Side window: 18" x 18"

10 gauge steel, powder coated with built in Fork lift slots.

Strong enough for 5 hp cutting yet simple to move around.

We wanted to keep the weight of the Slant 30 Elevator Friendly for those in the Jewelry business and R and D facilities located on an upper floor. We also wanted the machine to be able to be moved by a pallet jack for shops that want to use the machine as a second op machine for more than one CNC or Work Cell.

Left Side View

• Spindle Access Door 13" wide x 15.5" Tall

• For Bar Feeds a Hole is made in the door to allow the Bar to pass through into the Spindle

• Note the Far Right Photo of the Heavy Duty Dunham Collet Closer

• Note the how close the Spindle motor is to the Spindle. (Short Belt Eliminates Vibration)

• Below the Spindle you will see the Spindle Encoder Tucked neatly into the Back of the Spindle Head.

Rear View of Machine

• Right Side is the Electrical Cabinet with Door Interlock and Main Power Switch

• Left Upper Panel Lifts Up and Out via two handles allow complete access to the rear of the machine.

• Lower Panel Shows the All steel Pull Out Chip Drawer. Once pulled completely out you will have access to the 25 gallon Coolant tank.

Another rear view photo showing the Steel Pull Out Chip Drawer

This Picture Shows the machine with the rear access panel removed.

Note the Heavy duty Servos and the Military Class Connectors.

Main Casting "


Meehanite Furnace Aged to eliminate growth.

• Head Stock: 10 Inches Long, 11 Inches wide, 13 Inches Tall

• Base 34 inches long, 12 inches wide

• Saddle: 26.5 inches long, 10 inches wide

• Table: 15 inches long, 7 inches wide, 1.750 Thick

NEW XL Package Includes, Optional Table: 19.750 Long, 8 inches wide and 15 inches of X Travel

Axis Movements

• THK High Precision Linear Rails

• Continental Precision Ground Ball-Screws

• Direct Coupled Motors

• Extra Large Couplings

• Big Bearing Blocks (twice the size of some of our competition)

Another view of the Rails and Screws

Note the Direct Mount Servo and the Heavy Duty Limit Switch. Both X and Z have Hard Limits for Automatic Homing and Safety Over Travel

View of Z Axis Limit Switch

Some of our competitors cut cost by using software limits. Wouldn't you like the comfort of having a true hard switch rather than a maybe?

One more view of the rear of the casting.

Note the Massive Base Castings and the straight forward design.

Plenty of Tooling height, allowing the use of our big block tools or by using sub-plates you can use most any brand of tool holders

1.500 Inches as of January 2003

Huge Head Stock, 30 % Larger and 50 Pounds Heavier than our competition. Note our new Long Nose 5C Class Nine Spindle.

Also Available with our new 16 C Spindle